Clearances
Side. Minimum clearance required to any combustible material to the side of the appliance must be 150mm.
Shelves. Minimum clearance to the underside of a 150mm deep combustible shelf from the hearth must be 790mm, add 12.5mm to this
dimension for every 25mm increase in the depth of the shelf.
To light the appliance
Press down the control button at the right top corner of the surround. The fan shou anld bd the heneard to start initially on high speed
reducing to low speed, a spark will be heard and the gas will light at the pilot d coal (ifpositioned aat the centre of the front simulate
spark is not heard - check battery). Hold for a period of 10-15 seconds and release - the main burner will light.
A taper may light the appliance by placing the lit taper over the coal front at the ape conprtorolximate centre position and pressing th
button. See Fig 1.
The thermoselector control situated behind the ashpan cover (fret) is to be set to a pesiredosition which maintains the room at the d
comfort level, i.e. the higher the control setting the higher the mean temperature l takof thee timrooem. Adjustments to this control wil
for the effect in the room to be apparent.
To turn off the appliance and pilot - lift the control button.
IMPORTANT: After turning OFF or if the pilot and the appliance goes out for any reason, wait for three minutes before attempting to
relight.
Dismantling the Fire Bed for Cleaning
Allow the appliance to cool for 1 hour before handling any components.
Remove the loose coals, lift off the simulated coal front, and remove the coal supporte been shelf. Once all the fibre components hav
removed from the firebed check that no debris has fallen in or lodged the burner slylot rs.e Ifmove and y debris is present it may be easi
by using a small piece of thin cardboard to ease out any foreign matter. Be sure to rem deposoviets th ore cardboard after use. Any sooty
debris left on the coals may be removed by using a soft brush or by careful use of a ved oacuuut inm cleaner. . Cleaning should be carri
a well-ventilated area or in the open air, by gently brushing with the pieces held awng tay fherom your face so that you avoid inhali
dust. We do not recommend the use of a normal domestic vacuum cleaner, which may blow dust back into the air. Any sooty deposit
on the thermocouple probe can be cleaned of using a non-fluffy cloth.
It is very important that the coals and the coal bed components are laid as shown noy o exftra coals the or material may be used. If an
items become lost or damaged, replacements must be obtained before further use of the appliance.
Relaying the Coal Bed
Fit the coal support shelf and simulated coal front. Fig 2
Referring to figures 2, 3 and 4 lay the coals as follows:
1.Place 4 large round coals between the simulated coal front and the support shelf. Fig 3
2.Place 3 round coals between the gaps in the front row. Fig 3
3.Place the 5 small round coals between the gaps formed in the coals laid in 1 & 2 above. Fig 4
Cleaning the Front of the Appliance
The fire must be turned off and allowed to cool. The paintwork should be cleaned withim a s has aoft cloth or soapy water; the brass tr
clear lacquer coating to preserve thDOe polis NOT UShE Aed fBRiAnSiIVshES O. R METAL POLISH.
-3- |
ACEC
