Care and Use
Fire operation
For safety and to save compromising the visual look of this appliance the controls
have been located behind the canopy, To access the controls press the top of the
canopy as shown in Fig 11.The canopy will open out from the top to reveal the
controls.
Fig.11
Press here to open Open positionPress here to close
Flames (Fig. 12)
Fig.12
For Flame effect, press button.
This will activate the light unit and produce flame flicker.
(Neon on)
Heat (Fig. 12) Neon
Press switch I. This will activate the first element 1kW.
I II Press switch II. This will activate the second element 2kW.
Replacing the bulb
Disconnect the appliance from the mains ! Fig.13
Anti clockwise
Allow the appliance to cool.
Do not use bulbs of a higher wattage.
Ensure replacement bulb is 230-240 Volts~ 15 Watt,
with a Small Edison, Screw type fitting.
Ensure that the bulb holder is held securely
When removing or replacing the bulb.
Remove the coals (D).
Clockwise
Remove the coal bed (C) by removing the two brackets.
(Fig. 8).
Unscrew the used bulb (Fig. 13).
Re-fit in reverse order.
8 110803 |